Tye Bar Between Rear Pin Sockets

Tye bar made up prior to installation. I am not carrying out the instalation section of the wings as per the manual, and this is why the tye bar has already been drilled off and the fittings installed.

New Rear Starboard Hard Point

New replacement hard point trial fitted.

New Rear Starboard Hard Point

New replacement hard point trial fitted.

Port Side Rear Hard Point

New hard point installed on bed of flox and one layer of bid cloth overlapping the hard point insert by a minimum of 50mm all over.

Port Side Completed Hard Point

Peel Ply removed to show replacement hard point and layup.

Starboard Side Rear Hard Point

New hard point installed on bed of flox and one layer of bid cloth overlapping the hard point insert by a minimum of 50mm all over.

Starboard Side Completed Hard Point

Peel Ply removed to show replacement hard point and layup.

Starboard Side Completed Hard Point

Peel Ply removed to show replacement hard point and layup.

New Starboard Front Hard Point

New hard point installed on a bed of flox and covered with one layer of BID cloth and then peel ply

New Starboard Front Hard Point

Finished replacment hard point.

New Port Front Hard Point

New hard point installed on a bed of flox and covered with one layer of BID cloth and then peel ply.

New Port Front Hard Point

Finished replacment hard point.